Buy Dry Rot Sensors to detect Dry Rot in Wood and Masonry

	Fugenex Dry Rot Sensor detects Dry Rot before it damages your building		Property Repair Systems 01626 331351

	*Dry Rot Diagnosis, Dry Rot Detection and Dry Rot Monitoring*

How to prevent Dry Rot from damaging timber - install Fugenex Dry Rot Sensors

Go Directly to the Order Page

Eliminate the risk of Dry Rot:

New - the Fugenex Dry Rot Sensor

What is it?

* a simple to install treated wooden dowel that changes colour, from blue to yellow, in the presence of incipient Dry Rot

What does it do?

* it allows you to tell if Dry Rot is present at its earliest stages, in timber or masonry, giving you an early warning that action is required before your building is damaged

How is it installed?

* by drilling an 8mm diameter hole to a depth of 110mm in the 'at risk' timber or masonry

How does it work?

* the blue detector dye, that is vacuum impregnated into the wooden dowel, reacts to the chemical that Dry Rot produces - oxalic acid - at very low levels, turning the dye to yellow.

How much do they cost?

* about £15 - £20 each if installed by a Specialist during treatment works, or purchase direct via our Order Page

Don't let Dry Rot spread & destroy your building - Ring for Free Technical Support Now -

call: 01626 331351 for a 'Real Person' to chat about your needs, and Order Direct by phone

Go Directly to the Order Page

Next Day Delivery of all products by T.N.T.

Is it Dry Rot or not?

Dry rot can be nasty Fruiting Body covered in Spores

Dry Rot fruiting bodies ('mushrooms') on a skirting board

Dry Rot Sensors - in the box and one in the wall

(to the right of the box)

Property Repair Systems
Olympus Business Park, Kingsteignton Road
Newton Abbot, Devon, TQ12 2SN
T: 01626 331351
F: 01626 331143
E: help@propertyrepairsystems.co.uk

You can ring us now for Free Help - 01626 331351 - talk to a 'real' person - Angela, David or Kathy - discuss your problem with a Qualified Timber Decay Expert (C.R.D.S. + C.T.I.S.)

How to treat and eradicate Dry Rot

1. Eliminate the moisture source and establish the extent by drill testing

2. Remove all decay back to sound timber.(Note - no need to cut back and scrap good wood))

3. Inject Boron Ultra Paste, apply Boron Gel and surface spray/brush with powder in water Boron Ultra 12.

Go Directly to the Order Page

Dry Rot - Serpula lacrymans - beautiful!

Example

Manor House, Warwick - extensive infestation had resulted in massive areas of Dry Rot mycelium (skin) and sporophores (fruiting bodies - mushrooms) on timber and masonry. Previous treatments with conventional chemicals had failed to stop the spread of fungi. Boron Ultra 12 powder in water was applied by spray to timber, masonry and sub-sites, Boron Ultra Gel to end grain and vulnerable surfaces, Boron Ultra Paste and Boron Ultra Rods to 8-10mm holes drilled to prescribed hole pattern, to surrounding areas at least 300mm in all directions from the limits of the attack and to all timbers at or above 18% moisture content.

Go Directly to the Order Page

Dry Rot under a Timber Floor - collapsed